Rhino-shelter HOUSE-12W X 20L X 8H Manuel d'utilisateur télécharger pdf (Page 7)

Assembly Instructions House Style 12 x 20 x 8

Note: Snug the end panel by turning the turnbuckles or

repeating step 3 on a regular basis

V2.2

Do NOT Return Assembly To Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products Directly

Customer Service 800-447-7079 or 203-877-7070

MAIN COVER INSTALLATION

Step 1. To elongate the life of Main Cover, put a small

square of duct tape (field supplied) over each bolt head

on frame that comes in contact with cover. The tape

acts as a cushion to avoid rubbing damage to the cover

over years.

Unpack the Main Cover #MUC-5000 from the protective

plastic packaging. The line of grommets on the inside

(white) of the cover on the tie down Flap run parallel to

the sides of the frame assembly for positioning.

Once cover is oriented properly to the Frame Assembly,

pull Main Cover over frame assembly from the side,

being careful not to snag the cover on any member, bolt,

or other obstruction. Center the Main Cover over the

Frame Assembly with the Main Cover colored side

showing from the outside of the unit.

Step 2. Loosen the 4 remaining turnbuckles completely.

Place the turnbuckles into outer

hole in the foot of each

end arch. Tie off the rope coming out of the Main Cover

rope slot on either side to the turnbuckles. After

securing one end of the rope in the Main Cover, pull the

excess slack out of the rope and cover to tighten. Hold

the end of the unsecured rope and apply pressure

1 2 3 4 5 6 7 8 9

Pas de commentaire

Rhino-shelter HOUSE-12W X 20L X 8H Manuel d'utilisateur Page 7