Rhino-shelter HOUSE-12W X 20L X 8H Manuel d'utilisateur télécharger pdf (Page 6)

Assembly Instructions House Style 12 x 20 x 8

Door assembly is drawn over frame by tightening rope

and securing to turnbuckles at the arch foot. Turnbuckle

connects to hole on inside of arch foot as shown in

illustration. Frame must be secured in position so it

does not move as end doors and main cover are

tightened over frame. This step is key to good fit and to

prevent door movement in wind.

The rope channels should be located inside the unit, with

the frame members passing through the pre-cut slits in

the end panel/door. End Door Panels have pre-cut slits

that allow frame members to pass through so rope

pocket is inside unit. Replace and tighten the carriage

bolts after putting the end panel into position.

When putting on the doors, adjust the length to make

certain the doors do not drape onto the ground

. Adjust

by pulling more or less material over end arch. If pulling

them up puts too much stress on the slit where it goes

over the wind brace, use a sharp knife to cut slit another

inch or two to relieve it. The PE fabric is rip-stop weave

and will only separate where cut.

Step 3. Tie off one end of the rope coming out of the

end panel to a turnbuckle. Turnbuckle should be

loosened all the way and the open hook end attached to

the hole in the inside

of the end arch. Hold the end of

the unsecured rope and apply pressure downward with a

foot to remove excess. Re-adjust gathered material

evenly along door rope. This step is key to getting a

good door fit. Tie off the end off the rope to a second

turnbuckle attached to a hole in the foot of the end arch

on the opposite side. The end panel can be adjusted

further by tightening the turnbuckles.

V2.2

Do NOT Return Assembly To Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products Directly

Customer Service 800-447-7079 or 203-877-7070

1 2 3 4 5 6 7 8 9

Pas de commentaire

Rhino-shelter HOUSE-12W X 20L X 8H Manuel d'utilisateur Page 6