Rhino-shelter HOUSE-14W X 42L X 15H Manuel d'utilisateur télécharger pdf (Page 7)

Assembly Instructions RV Style 14 x 42 x 15

V 2.2

Please Do NOT Return Assembly To Dealer or Store. For All Questions and assistance, contact MDM Products directly.

Customer Service 203-877-7070 or 800=447-7079

ANCHOR STEP 1

Place DRIVE ROD into the cup of the anchor head.

Using a heavy hammer or sledge, drive the anchor

into the ground until 6-8 inches of cable remain

above the ground. Remove drive rod.

ANCHOR STEP 2

Place the Drive Rod through the loop in the anchor

lanyard. Pull upward to set anchor in the ground.

ANCHOR STEP 3

Slip one side of the U-bolt through the eyelet at the

end of the anchor cable. Attach the cable to the leg

upright with the U-bolt and tighten. Ensure there is no

slack in the cable. Slack can be removed by

wrapping the cable around the tie-down rail.

Anchor Loop

Drive

Rod

END PANEL/ZIPPERED DOOR INSTALLATION

NOTE: End Panel/Doors MUST be installed

BEFORE Main Cover.

END DOOR STEP 1

Remove the Carriage Bolts holding the Top Crest

Cross Rail and Side Cross Rails to the End Arch.

(these are the ones you left loose). Bring the Door

Panel up to the outside of the frame arch, keeping the

white side in, grey or green side out. Align the

material evenly over the arch.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Rhino-shelter HOUSE-14W X 42L X 15H Manuel d'utilisateur Page 7